New 3D measuring equipment in Boecillo
.
Aerostructures

New 3D measuring equipment in Boecillo

05.08.2019
New 3D measuring equipment in Boecillo

Aciturri Aerostructures Boecillo has incorporated into its technological catalogue a new 3D coordinate measuring machine (CMM) that will allow us to improve our workflows in final processes.

With a wide range of measurements and a wide variety of probes, it offers a CMM system appropriate to each need.

Thanks to its automatic dimensional inspection system, integrated into a single device, it reports a reduction in current times, thanks to the standardization and repeatability of the measurement processes, as well as the possibility of implementing inspection lots.

At the same time, we will achieve greater reliability in CNC machining processes, since, by having more accurate data, we can calculate its capacity and center them.

Equipped with CLIMA technology, the machine has a total of 11 sensors located in critical areas of its structure, which offset the effect of temperature on the accuracy of measurements performed on a coordinate measuring machine. In addition, it is prepared to use point-to-point probe, continuous measurement or laser scanner.

Its software allows to make all types of measurements, calculations and measurement reports, and is compatible with other technologies of the same manufacturer. The acquisition of this software (PC-DMIS) allows to unify the metrology system between our plants, specifically with Ayuelas and Tres Cantos, where these 3D measurement processes are also carried out.

You can share this page

InstagramInstagram
LinkedinLinkedin
TwitterTwitter
YoutubeYoutube